RDZ drag pipe

[BlastrMastr240]

Hey i got the RDZ pipe for my blaster but i cant figure out for the life of me how to get this to fit. it sits on the tight side next to the foot brake and mounted onto the foot rest? does it come with any peices for mounting onto the engine (springs, a new manifold peice, gaskets, anything?) :-/

I have tried mounting it and it never fits. thanks.

p.s. if you could take some close up pics with it on a blaster that would be awesome.

 

[blasterdemon7]

RDZ? It sounds like your running a drag only pipe.

 

[sicivicdude]

Post some pics of the parts you have. It sounds like you're missing some parts. Not too complicated a system to figure out. It has a cylinder adapter, spring setup, and pipe. The bracket that mounts on the foot pedal is usually welded on, on the ones I've seen and then a bolt goes through the hole in the end of the pedal into the bracket.

 

[BlastrMastr240]

Here are all the parts i would have to install the exhaust.

 

[BlastrMastr240]

If you go to my profile u can look at the pics a lot larger.

 

[BlastrMastr240]

i dont have the right spring set up, the mount is welded on with the proper bolt included, and the engine adapter is the longer one i think.

 

[StrokedTater244]

you are missing two spring holders and one spring. the holders go under the flange nuts and are L shaped. they have a hole in them to hold the springs.