QUICK CLUTH QUESTION

[CC&Fabb]

I had to remove my clutch to replace my main seal. I was just wondering if it matered what order I put the clutch plates back in. I put them back in the exact reverse order that i took them out. Is that the only thing that I need be be concerned about?I:I

 

[89custom]

ok first up, you gota remeber to line the dots up on the basket and the inner part. then the first plate will be a fiber, then steel, then fiber, then steel and so on. when you get to the second last fiber, it has a bigger inside diamtetre because theres a spring washer that fits in it. put that in then there should be another steel then friction to top it off.

anyone confirm this please? thats ow i remeber it.

 

[CC&Fabb]

i put the steel plates and the fiber plate back exactly how they came out. i saw there there was a dot on the pressure plate so i lined it up with the dot on the clutch basket. That is what you are taking about right??

 

[89custom]

well the inner and outer clutch basket orwhatever the term is have dots on them. they need to be lined up BEFORE you put clutch plates in.

 

[CC&Fabb]

I am not sure i did that so, ill take it back apart and make sure that i am ok.

 

[89custom]

if you dont line them up it doesnt pull right so doing that is very important

 

[CC&Fabb]

yea i had them lined up. the dot on the clutch boss with the dot on the pressure plate. I could test my blaster out if I had a clutch cover gasket.

 

[djack12]

hey are you ready to ride yet?

 

[The Ox]

89custom is right. Just line up the outer and inner basket. The second to last ring is also right. That is counting from the outside. Add a little oil too..Also there is a adjuster that needs to be adjusted too before you put the cover on..

 

[CC&Fabb]

what is the adjuster i need to know about and what do i need to know to ajust it? is it that pin that goes through the middle of the clutch?