2002 Blaster-Stock
I have a question about the crank case cutout on the stator side (at the top) which is covered by a rubber grommet. After going through the bike, it appears that some jack-wagon put some sort of a pry bar down it to get the stator off. Anyway, while doing this they apparently chipped a small portion that butts up to that cutout. Given that, I am going to repair it so that it will seal completely. My question is, what is that cutout for, is it some kind of vent or a tooling cutout from the manufacturing process? Because if it doesn't affect the engine I am going to completely seal it along with the chip. Any help would be greatly appreciated.
Thanks,
Jon
I have a question about the crank case cutout on the stator side (at the top) which is covered by a rubber grommet. After going through the bike, it appears that some jack-wagon put some sort of a pry bar down it to get the stator off. Anyway, while doing this they apparently chipped a small portion that butts up to that cutout. Given that, I am going to repair it so that it will seal completely. My question is, what is that cutout for, is it some kind of vent or a tooling cutout from the manufacturing process? Because if it doesn't affect the engine I am going to completely seal it along with the chip. Any help would be greatly appreciated.
Thanks,
Jon