Push lever Assy

[nickster525]

Guys can someone assist me before I buy something that's not needed. how do I drive out the inner push rod to get my push lever assy seated in place? is this push one continuous one or what?

 

[Awk08]

there are 2 push rods seperated by a ball bearing.
the inner one can be pushed toward the clutch from the actuator side with the actuator out and using a thin flat screwdriver to push it back into the cases towards the clutch.
you may need to loosen the adjustment nut, and/or pull the pressure plate with that side rod attached to allow the inner one room to move into the cases

 

[nickster525]

how do I get the push lever assembly to fall into place? I was able to get the inner rod out with the bearing. but still couldn't get the push lever to fall into place

 

[Awk08]

if the inner rod is out, the only thing to prevent the actuator from going into place is a boogered seal or bearing,
or the case has chain whack pushing into the actuator area <

 

[nickster525]

any solutions to get this push lever into place?