Porting and polish job

[blaster003]

I decided to port and polish my cylinder myself what do you guys think?

 

[bummer981]

Nice job, good work.

 

[Larry's Shee]

Did you raise or widen the ex? Is the ex same dia of the gasket at the flange? Gasket matched at base?
Overall nice work !!

 

[MURPH]

Nice job! but those transfers could use some attention

 

[Blaaster]

A little more rounding of the sharps here may be beneficial to avoid turbulence.

 

[Larry's Shee]

I know this will sound crazy, but I like to "feel" the flow. Smooth and round as a baby's butt. No sharp edges, no ripples, no sudden change in cross section/size.

Least you knew not to polish any of the intake/transfers.

 

[blaster003]

Yeah I didn't take too much off the ports really just to clean them up and smooth them up and the picture of the transfer ports were took when it wasn't done. And thanks for letting me know about rounding the intake