please reply ASAP!!!

[xcaseylanex]

ive been looking for quit some time now for a right half of a case because the previous owner to my blaster jamed a bolt in it cause he lost the other one its the bottom right bolt ts the bolt right below where the motor mounts to the frame.



eBay Motors: 1999 YAMAHA BLASTER 200 YFS RIGHT CRANK CASE COVER (item 120406638234 end time Apr-21-09 18:56:14 PDT)

well i found this but its to a 99 and i have an 01 will it mount up and most of all based on what i told you will it solve the problem im kinda scared cause i think when i take that bolt out it cross threaded the hole it goes in

please help me as soon as possible to auction is almost up

 

[blaster240R]

yeah it will mount up

 

[ron89]

yea that case will work.

 

[xcaseylanex]

im sorry i dont no the proper terms for the parts but its the bolt that goes into the ride side of the case with the yamaha name on it farthest up and right below where it mounts to the frame, if the threads inside are screwed up when i pull htis bolt out what do i do then?

 

[specialized7]

i have one of those for sale.

 

[xcaseylanex]

scratch that last reply its the plactic peace next to the yamaha peice, im sorry i dont no names of parts but yeah its the gray lookin one

 

[xcaseylanex]

can that be fixed? cause he put the wrong bolt in it it wont even go all the way in. but i wanna fix it and it leaks like a biotch

 

[quam]

i thnk you're talkin about the clutch cover. you drain the oil, pull the cover, take a drill that is a smurf hair bigger than the hole and drill it. also drill the corresponding hole in cover. then you get a tap that is 2mm larger than the screw and tap the hole. get you a bolt that matches the newly tapped hole and you're golden.
or use a helicoil.

 

[xcaseylanex]

how much is a tap and do you think its that hard to do honestly never done somethin like this before

 

[245stroker]

sounds like your talking about the oil injection cover. The plastic cover towards the front of the motor on the right side. If its leaking oil, its because of the injector pump or your oil injection block off plate. Put some rvt silicone on it and tighten it done, then put the plastic cover back on

 

[xcaseylanex]

yeah thats what my buddy did before me but the bolt that bolts it on on the front most part of it was jammed in there its not the right one and wont even go down all the way so im sure when i take it off the threads to put a new one in will be cross threaded so im stuck right now

and i think it leaks out of the spindle area