OK! So i bought this:
BGsys.dk I:I
It will fit the flywheel....which I can use to tightn the primary bolt and the flywheel.... But unfortunatly it wont fit as a clucth holder... X(
BUT : one question .. Can i also use it to the clutch? I mean it will not fit the clutch as a holder but can i hold the flywheel and then tightn the clutch bolt? (80nm) ... Is it possible to do that? or do i need the specific tool to hold the clutch boss also?
Could be great if one guy could hold the flywheel while I could tigthn the clutchbolt on the other side.. .
Or would it put to much stress on the flywheel / small key at flywheel?
BGsys.dk I:I
It will fit the flywheel....which I can use to tightn the primary bolt and the flywheel.... But unfortunatly it wont fit as a clucth holder... X(
BUT : one question .. Can i also use it to the clutch? I mean it will not fit the clutch as a holder but can i hold the flywheel and then tightn the clutch bolt? (80nm) ... Is it possible to do that? or do i need the specific tool to hold the clutch boss also?
Could be great if one guy could hold the flywheel while I could tigthn the clutchbolt on the other side.. .
Or would it put to much stress on the flywheel / small key at flywheel?
