Pipe fitment

[coady]

Ive picked up a pipe from the states, its been shipped and looks sweet, its far too cold outside to fit it at the moment but Ive had a look etc.

It looks like it will fit but I think i may have a problem, there is no flange? I mean, no way to bolt the pipe to the cylinder? are there parts missing? Ive checked the packaging etc and it al says its correct for the blaster, but there are no instructions.

 

[J4M1E333]

what pipe you end up getting coady? im still looking for one for mine.

 

[1997blaster]

there should be a flange and a spring

 

[coady]

got teh doma pipe, had to get it imported but it cost 160 all in, bargain really, well until i found out theres no flange or spring!

 

[98blaster+4]

well i dont know what to tell ya about no flange, but as far as a spring goes you can use a stainless steel plumbing spring ,, just get the right length. you might be able to reuse your old flange from your old pipe.

 

[TechBlaster]

well i dont know what to tell ya about no flange, but as far as a spring goes you can use a stainless steel plumbing spring ,, just get the right length. you might be able to reuse your old flange from your old pipe.

I am going to agree here. If the pipe kit was new and did not come with the flange/spring kit chances are it calls to REUSE the stock stuff, just makes sense. Give it a try, it may work.

 

[coady]

is it normal for the flange to be a seperate part? I have contacted the seller and he is supplying the flange and springs, i don't understand how it will fit though?

 

[yb200]

you bolt the flange to the cylinder and slide the pipe on the flange and the springs hold the pipe on the flange.....hope that makes sense

 

[coady]

I get it now, I guess all will become clear when I actually get the part in front of me, looking forward to start modding!