Parts Swap
- Thread starter 79 bronco
- Start date
banshee carrier is not a straight swap. The wr200 was a case reed motor. You may be able to bolt it on but then you would have a water cooled blaster with no intake. Kind of hard to run that way.
Looks pretty close based on what I've learned about the Blaster so far. The bar clamps are shared between the Warrior, Banshee, and Blaster too. I got a trick Nac's Racing one for dirt cheap off of fee bay and used the stock clamps as risers, it was cheaper than a riser kit and it looks cool. You can also get the style that holds the ignition if you want to can the plastic cover on a pre-03.
Last edited:
I do know that the wr200 in the usa is a case reed motor, but i dont know if yamaha made any older none case reed wr200 that was sold some were else.
Looks pretty close based on what I've learned about the Blaster so far. The bar clamps are shared between the Warrior, Banshee, and Blaster too. I got a trick Nac's Racing one for dirt cheap off of fee bay and used the stock clamps as risers, it was cheaper than a riser kit and it looks cool. You can also get the style that holds the ignition if you want to can the plastic cover on a pre-03.
that clamp look really nice
Thanks! You can't really see it in the pic but I inverted the old top clamps and put them under the bars, this is good for about 3/4" of rise.
Similar threads
