Oil injection please help..

BastinPastYou

New Member
Dec 4, 2008
33
1
0
Hi, I just bought a blaster but im kinda worried. I put fresh gas in and rejetted the carb to a 260 and now it runs very poorly. Did someone already put an oil injection block off kit on? There is NO oil lines going into the carb just 2 wires and a gas line. Where is the oil injection suppose to be!? :(

I see a vacume line running into the crank case and then a vent line beside it. Oil is leaking out of the vent line.
 
Last edited:
Is there an oil tank ? It should have a hose running to the right side case cover of the motor. Then another one coming out of the right side case cover going to the carb. If there is not one check to see if the hole is left open in the carb. DId it run fine before you rejetted it?
 
Is there an oil tank ? It should have a hose running to the right side case cover of the motor. Then another one coming out of the right side case cover going to the carb. If there is not one check to see if the hole is left open in the carb. DId it run fine before you rejetted it?

It has one hole going into the crank case and the other hole is left open. I still have the bottle on there and the line running to the case. No lines to the carb whatsoever.
 
You see where the oil line from the tank goes in the case. Is there another one that comes out that same spot or no ?
 
Look in the manual and see if the oil line spot on the carb is plugged up. If not, then plug it up and mix your own gas and do the free oil block off mod incase its not done so its not running the oil pump dry.
 
if theres a nipple on the right side of the carb, then its blocked off and you need to run premix. sounds to me like they unhooked the pump and left the tank in place. drain your gas and try some 32:1 and see if that helps.