i have an 01 blaster with a 3mm stroker kit a 20 over v force reeds fmf fatty and a fmf 2 core exhaust k & n air filter i down sized a tooth on the front sproket and i believe its been jetted i mix my gas half a quart for about 4 or 5 gallons. im haveing problems with it now when it gets all warmed up it doesnt like to just run i have to be in the powerband to move at all i have to rev it up till i get there sometimes push the throtle in countless times to get it to go to power band and sometimes when i down shift and let out of it a bit it does the same thing seems like its going to shut off. i climb a lot of hills so this can be a problem when im goign up the hill and i go to down shift for more power and it decides to bog out. does anyone know what i can do
not running right need help
- Thread starter njf5020
- Start date
the floats in the carb could be stuck or not properly adjusted, or your jetting is off. Could be that there's something up with the reeds. Did you put the spacer plate in properly for the crank?
yeah the plate is in right and i dont know about the jets i know it i went to run it the week before and i havent in a while and when i turned the gas on it just ran out of the carb out of all the hoses so i know the carb was filling with gass i took the bowl off and moven the float up and down and it stop and then this happend
Similar threads
