no gas to the spark plug?

[Bwildd]

I have a 2001 blaster and it ran a couple months ago kinda well, up until the reeds broke. Now they have been replaced with Boysen reeds and a reed spacer. After that i rebuilt the carb and cleaned everything very well. The quad will now not pull any gas to the spark plug for it to fire. The spark is good but it is not getting any gas. I pulled the reeds out and they were wet with gas on both sides. This is where I am currently stumped. I searched these forums and others to find really no end for the my question at hand. I have come across where it seems that it could be a compression problem but if you put your finger over the hole and kick lightly it will blow your finger off and youd think the compression is fine. Anyone have any ideas where to start now? Any kind of help is welcomed. Thanks

 

[ruthless_one3k]

I would suggest testing it with a compression tester. The difference between running and not is to hard to gauge with your finger. This could also be an air leak around the intake or maybe even a base gasket leak. try pull starting it see if that works?

 

[Bwildd]

We thought it might have been the gaskets leaking at first and replaced them but to no avail it still wont run.

Sorry I am still a little noob to sport quads, when you say pull start, do you mean an actually pulling it because it only has a kick start on it with no electrical start.sorry I am used to riding my popo and never really messed with sports quads.