New Owner with Engine/Trans Oil/gas mixure Questions

[XSkater2099]

Just bought a 99 blaster and i have a few questions about oil changing on it.

The fill hole for the crank case is on the case it self, correct? that take yamalube about 3/4 quart? and the drain for it is under the case right?

the fill hole under the seat that says engine oil fills what? and what do i use for that and how do i drain that or is it the same as the other?

thanks for answering my prob common questions, lol

Also the gas mixure is 32:1? i am heading out today to get some fresh gas for the bike and i didnt see anything in the owners manual about the mixure

 

[blaster biotch]

the filler hole on the case is for the gear oil and yes 3/4 is correct this oil only lubricates the gears clutch and what not. the filler on the back is for 2 stroke oil only. u dont have to drain it , it is a consumable and is mixed automatically with the fuel at the carb. u dont have to worry about mixing the 32:1 , the set up u have will do it for you. i would suggest in the near future you do away with the oil injection and premix your own fuel.

 

[Wildcard2]

it wont say in the owners manual about your mix. The blaster was set up to do this for you. The first mod you will want to do is get a block off plate, and mix your own. reason bieng when the self mixing stops working it usually causes damage.

 

[djack12]

ya just dont waste your time with the oil injection system. block it off, and pre-mix yourself.

second use a good gear oil for the tranny. Bel Ray Gear Saver so something like that. you wont regret spending the extra money on it.