Need Carburetor Help! Fast!

[daulton_w]

Okay, I need help reseting the needle vowels In my carb, Cause my throttle Is not working and somehow It's pouring gas out of the bottem of my carb.

 

[Stanimal]

probably have a stuck float. pull the bottom of the carb apart and clean it really good.

 

[Larry's Shee]

Needle VALVE? Is it comeing out the overflow tubes or bowl drain at very bottom of float bowl? Did you have carb apart? Is the little wire on float needle valve on the tang of the float?
Did it just start doing this or after you "fixed" it?

 

[smalls]

have the same problem and noticed the shut off valve wont stop the flow eaither??? just filled the tank too... pulled the hose off the shut off and its pouring???

 

[will9084]

could be needle stuck try barely tapping it with somthing sometimes it unsticks it

 

[NEONNIGHT34609]

i just went though this. my float valve had trash in it but i ended up just changing it since i had one left over in my carb kit

http://www.blasterforum.com/engine-13/carb-leaking-again-40966/

 

[Luni]

have the same problem and noticed the shut off valve wont stop the flow eaither??? just filled the tank too... pulled the hose off the shut off and its pouring???

That sounds like your fuel petcock is faulty.

 

[jlsparky7]

Check out the carb cleaning vid in the link in my signature.