Need Advice Please: Warrior Front Brakes on 2001 blaster?

[blaster253]

Hi Everyone,

I just purchased a 2001 blaster that already has the rear hydro brake. I have an opportunity to get the front hubs, rotors, calipers, lines, master cylinder, lever from a Yamaha Warrior. What else would I need to get these on my Blaster in order for me to have Front Hydro brakes? Your advice is greatly appreciated!

 

[Bluesman]

I know '90 and newer Banshee stuff works. I'm fairly sure the '90 and newer Warrior stuff is the same, but I can't promise.

Then you need '03 to '06 Blaster spindles or Ken Oconnor conversion spindles.

 

[blaster253]

Thanks for the reply Bluesman. Yeah, all I can really find is people saying they use the 90+ Banshee components but all I have access to for a real good deal is a 90+ Warrior. I was planning on getting the KOR conversion spindles but wasn't sure they'd work with all warrior components.

 

[Bluesman]

Go here and look up the part numbers of the calipers, hubs, rotors, and bearings for Banshee and Warrior and compare to see if they're the same.

https://www.rockymountainatvmc.com/oem-parts/Yamaha

 

[blasterdemon7]

The Warrior front brakes will work.

 

[jbuckster07]

the only thing that will not work from a 90+ warrior are the spindles. You will need to find a set of 03+ spindles OR send your spindles to KOR in exchange for modified 88-02 spindles, think its $125. but all the warrior stuff should bolt up to them no problem.