so i bought another blaster yesterday and did a compression test had 70psi after 5 kicks kickstart was hard to kick but does move. so i figured rings a seized so i took the topend apart today and piston rings and sleeve look great the piston was sitting in the bottom so i went to pull it up to look at the rod and crank and it wouldnt move. i got it to come up by pushin the kickstart down. it doesnt move up and down by hand like my other blasters does so my question is does that sound like a rod bearing? and how hard is that to fix and how do i go about fixing it?
motor ?s
- Thread starter tcoop474
- Start date
i would do a hole bottom end get a hot rods rod kit and a all balls crank bearings and seals check it out on rockymountain atv mc cheap and with the rod bearings u have to split the crank halves take it to a crank shop
ight thanx and also im almost done redoing every thing on bnasty (in sig) and on a thread a while back somebdy posted a link to a company that does nothing but jets for the carb does anybdy know that site it think it was like jets r us or something idk anybdy know?
^ That's probably a good place to start, but the only way to tell for sure is to do a proper plug chop
