Hola guys....so I bought a used Toomey pipe and silencer from a member online here. After trying to instal it i noticed that the springs are missing which is no big deal...go online, found the springs, on their way. My big problem is this....is there a spacer that is supposed to go between the motor and the pipe? If so i am missing that part and need to put a "wanted" listing out. If i'm wrong and i am just missing the small picture here on instal then please let me know. This is the problem with buying used which sucks but i cant complain because nothing will get done. So all the help would be appreciated. Thanks so much
Missing Toomey parts??
- Thread starter Mac_49
- Start date
Are you talking about the flange? The flange mounts onto the exhaust on the cylinder, and the expansion chamber slides over the flange, which is held on with those springs
On the pipe....literally there is nothing. Just a pipe. No attached pieces or parts or nothing. Just the pipe. On the stock I pulled off there obviously was the flange that bolted to the two studs in the block.....but this pipe doesn't even have that?
you're going to have to contact toomey racing to aquire a flange, might as well see it they have the bolts needed too ?
http://www.toomey.com/
http://www.toomey.com/
I guess my biggest concern is.....if it goes on the way stock does.... How does one get that flange off without cutting it let alone get one back on then? :/
Well good lol at least that's a small relief....i was hoping it wasn't like the stock pipe where the "flange" is basically built "on" and around the pipe otherwise i'd be SOL. Thanks guys...no idea if Toomey sells that separate but i'll give it a shot
Yes, you can buy all the parts to a Toomey exhaust system separately! The flange is billet aluminum and is probably the best design on the market. You'll need the flange, two springs, internal O ring, exhaust donut gasket, and two nuts to secure it just like the stock pipe. No bolts required.
