Kill switch

[sam0840]

I have a kill switch that needs to be replaced. The switch is good but its an older style with a rubber stopper thats rotten so it doesn't hold the switch down. is there a way to just disconnect it and still allow the engine to run? I was going to get a new pro design type one but if i dont have to spend 40 dollars then I dont want to.

 

[wwholden]

Just cut the wires off clean. A open circuit will allow it to run. A closed circuit to ground will cut the spark therefore killing the engine. Simply cut the wires and wire tape the ends.

 

[Wifesblaster]

Or you can get the dirtbike style for 10 bucks on eBay. That's what I did.

 

[sam0840]

So if i just disconnect the wires going up to the switch( they have they own quick connect connection) it should be ok? what exactly are you referring to the dirt bike kind of switch?

 

[Wifesblaster]

This is what I use. I got tired of finding out that it wasn't on run after I've kicked it 4 or 5 times. Cheap and works like a champ. Then all you do is buy a toggle switch for your lights and your good to go.
Kill Switch 50cc 250cc Dirt Bike Pit Bike ATV Honda Kawasaki Yamaha Suzuki SSR | eBay