is it possible to even get the head of a 1981 kdx 250 on an 2002 blaster? just trying to make a bad bike
kdx 250 head on '02 blaster?
- Thread starter okblaster_02
- Start date
assuming it can match with the cylinder bolt stud pattern i would say when the piston comes up and hits the kdx squish band ,im sure it will make one bad bike :-D
kdx has a 70mm head (actually bigger than that even for clearance)but your bore is only 66mm that means the head gasket wont seal on the deck ,thats only one of the million issues youd have.wait when you say head are you menaing the cylinder itself??????????????????????????????????????????????????????????????? becuase the build issues would be even worse then lol
yea^^if u want to do something like that then i would do a yz 250 motor swap,or somethingl ike that
is there any cylenders/heads that will bolt up? i think a dt200 is the same isnt it? but it would be just a replacement not an upgrade??
no can not just put a dt200 jug on it cause you need to change the case so you can run a water pump too
ahh sh*tt i guess im selling the kdx head and getting a suzuki ltr500 head!! and with my internal turbo and flux copacitors ill be running nascar!! yeah!!!
Similar threads
