jettin for my shee???

[bobdryerr]

ok my shee pic below has after market reeds an uni air filter bored 80 over an has power pros exhaust.. now that i got the carbs all taken apart an clean up im looking at the main jets an there a 260 would that be 2 small for the 2 carbs for my shee... i live in iowa an its cold right now.. do you guys think i should be running a bigger jet in both carbs or is the 260 main fine :-/

 

[Blasterdude27]

That sounds about right, they have the same size carbs as a blaster so jetting is about the same.

 

[bobdryerr]

ok thanks man i wasnt sure cause i was thinkin maybe they where suppose to be like a 290 or 295 wasnt sure thought i better ask.. dont wanna blow her up right after i rebuilt the darn thing

 

[370]

heres a decent baseline.. 25 pilot, stock needle 4th clip and a 270 main.. adjust accordingly from there.. i woudl assuem that iowa is in the 0-1000ft range correct? you may end up anywhere from 250-290 depending.. 270 is a great starting point though if your using an airbox with a modifed lid. if your running pods then you'll be in the 280-300 range for main. can you tell i've jetted a few of these? haha

 

[Tim Lutz]

Talk to power pro. I'm sure they have a few dyno hours testing what works with their pipes. When I got my DMC pipes I called them and told them my mods and they recommended 310 mains and it was perfect.

 

[Kennedy_Power]

In this weather I would go all the way to 360 main and work down

 

[BLASTER HP]

^^^x2 you'll be above 300 in cold weather