hi can somone tell me what are the ports that i would raise or lower is it the two that sit next to each other on the intake side or the smaller one above them info please
intake ports
- Thread starter blaster man1
- Start date
better research it alot before grinding away..not sure if there is videos on it,but alot of pictures
look in engine mods section
look in engine mods section
what is the small one at the top for i have old head i am going to practise on this then post pics to c what us think
That is the boost port. Do not raise unless you plan on doing the other transfers (and you cant do that properly without a right angle piece) You could raise the exhaust a tad but I firmly suggest doing some homework before grinding at things. Videos and reading etc.
the head i will be using is scrap when i am done will take it to my local performance garage and get them to check it over i am going to port and polish exhaust and take 60%of the bore off the top ov exhaust port. clean out transfer ports raise intake port 1mm lower 2mm and getting head rechambered 22cc what do u think
