honda rims

[blaster99]

will 400ex rims fit on the banshee

 

[brandoz28]

no .

 

[blasters/banshees]

N o

123456789

 

[4cfed]

yes............ if you buy banshee hubs with the honda 4x110 bolt pattern

 

[brandoz28]

yes............ if you buy banshee hubs with the honda 4x110 bolt pattern

unless there's an aftermarket option for that, banshee/warrior/raptor are 4x115

 

[blaster99]

oh ok,how hard are tires to swap

 

[4cfed]

unless there's an aftermarket option for that, banshee/warrior/raptor are 4x115

there is.... i know a guy with 400ex rims on the back of his banshee... i looked into it can buy hubs with that pattern or tap stock 400ex hubs onto the banshee axle.. idk he claims they fit right on but i read other wise

 

[blaster99]

yea i could always drill holes to make them fit

 

['blanshee'man]

check the bolt pattern thingy 4cfed posted in suspension lol

 

[brandoz28]

hmmmmmmm i don't think i'd "tap" hubs on that don't slide on lol. and swapping tires is worth taking it to a shop to do unless you are good with the son-of-a-biotch tool....you know, the one you throw across the garage/yard while screaming son-of-a-biotch

 

[blaster99]

hmmmmmmm i don't think i'd "tap" hubs on that don't slide on lol. and swapping tires is worth taking it to a shop to do unless you are good with the son-of-a-biotch tool....you know, the one you throw across the garage/yard while screaming son-of-a-biotch

im talking about the rims

 

[brandoz28]

if they bolt up its not a big deal....if the bolt pattern isn't right, you need to either dismount and remount tires or drill holes, which is fairly hard to do correctly

 

[blaster99]

drilling hole in the rim to fit isnt hard,take the ub off put somegrease on the end of each lug to make a mark and drill away

 

[brandoz28]

what if you don't nail it center?

 

[4cfed]

remeber my black and blue 250x... that had warrior rear rims on it.. holes were drilled out

 

[brandoz28]

if you're confident doing it go for it

 

[blaster99]

yea it doesnt take rocket science,but it is easy to make a mistake,thanks hopefully theyll bolt right on

 

[4cfed]

yea it doesnt take rocket science,but it is easy to make a mistake,thanks hopefully theyll bolt right on

ya.. just gotta drill out a big on the holes closer to the center of the rim.. i think the guy that did my warrior rims just drileld the holes bigger all together

 

[blaster99]

yea ill figure something out,thanks guys

 

[nd jat]

Cut a piece of card board to fit snugly as a bar across the inside of the rim, Then use a compass to scribe the radius of ur bolt pattern. That should center the rim on the hub closely.