high idle helpp?

[bubba813]

Okay so i just got my blaster all back togather. I just fired it up & now it idle's really high dose Anyone Know What Cause that?

 

[cole454]

Does adjusting the idle screw change anything?
Stock or a/m carb?

 

[Larry's Shee]

X-2^^^ Also look in carb to see if slide is all the way down (not hanging). Have you done a leak down test ? Air leak/very lean condition will also cause this.

 

[bubba813]

It dosnt change at all when i try idling it down & its A stock Carb it ran fine before when i drived it but now its acting up. & I havent did a leak down test yet though.

 

[Larry's Shee]

Make sure throttle cable is seated down into carb and into throttle. Do you have TORS "brick" still on top of carb? Looked into carb yet?

 

[bubba813]

Okay ill try that & i Have the eliminator kit on it i removed the tors.

 

[1995blaster]

You just put it all back together? Like put the motor back together if so its probably a air leak does it also have hanging rev's

 

[jlsparky7]

Sounds like an air leak if the carb and throttle cable are set and working.

 

[dbowhntr]

will it run normally with the choke on?

 

[joshrabbitt14]

Check for an air leak that's what it sounds like

 

[bubba813]

Thanks Guys for the help but it was the throttle cable hung .but i road it a couple times now when i start it it starts at a low idle then idle's fine

 

[Racer51]

Is it possable that you you may have put your reeds upside down. It will in most cases rev high and wont idle no matter what you do. Is the rubber nub at the top and cause an idiling problem just like an air leak. At least thats what will happen on a banshee if the reed boot is upside down......more pictures the better we can help you use TinyPic - Free Image Hosting, Photo Sharing & Video Hosting andcopy paste the IMG code is the easyiest way I know how to do it.

 

[Blasterbuilder]

ive had this problem and it wasnt an air leak all it was is the air screw on the carb was to far out i turned it in one turn and it solved the problem