Hey sorry, but one more question.

[Blue Bowtie]

When I pulled the case the spring and kickstarter shaft kinda fell out, anyway I thought I had everything correct and put it back together, and then I found a kinda thick(1/16"-1/8") brass/copper washer up against the tire after I was done.

So I'm guessing I dropped it out of the case, but I don't know where it would go.
Please help.
Austin

 

[motoman9911]

Can you find a schematic for it anywhere online?

 

[royalt67]

manual
www.rydindirty.com/blastermanual.pdf

 

[scotj77]

I am not familiar with a brass or copper washer anywhere in the clutch cover. unless it was used as a replacement for a lost or damaged washer in the past. was it covered in fresh oil or could it have been something just lying around?

 

[Blue Bowtie]

I looked at some exploded views and I don't see it anywhere in the side case.

So, I think it might be washer off of the drain plug, as I dropped the drain plug when I pulled it to drain the case, and wasn't paying much attention, and there wasn't a washer on the plug when I re-installed it.

I guess this is what I get when I get in a hurry and don't pay as much attention as I should.

Thanks for the help guys.

 

[scotj77]

that sounds right. there is a brass washer on the oil plug. like I said I don't know of anything brass or copper inside the tranny.

 

[OConnor Racing]

No washers will fall out when you pull the kick start out.