help with electric power from motor

[mx5coco]

i have a 1996 blaster motor, i swapped it into a street legal zongshen frame and carried over the blaster wiring harness with the little black boxes. the wires to the throttle thing are gone and so are the ones to the giant crazyness on the carb. i pretty much just have the coil hooked up so it can run, i found a hot wire and tried hooking it to my headlight but it keeps blowing my bulb. what wire should i use? btw this wire is hot enough to bite you if you ground through your hand... is there a wire i can just run straight to lighting?

 

[Quadrider10]

i have a 1996 blaster motor, i swapped it into a street legal zongshen frame and carried over the blaster wiring harness with the little black boxes. the wires to the throttle thing are gone and so are the ones to the giant crazyness on the carb. i pretty much just have the coil hooked up so it can run, i found a hot wire and tried hooking it to my headlight but it keeps blowing my bulb. what wire should i use? btw this wire is hot enough to bite you if you ground through your hand... is there a wire i can just run straight to lighting?

no. has to be after the voltage regulator.

 

[mx5coco]

which of the three black boxes is that?

 

[Quadrider10]

none. its a silver box that says 12v

 

[mx5coco]

great, there isnt one on my donor blaster, thank you for your help

 

[Quadrider10]

np. u can get one on ebay for like 5 or so. just type blaster voltage regulator. there all the same

 

[mx5coco]

thanks. ima see if i can wire in my zongshen one first

 

[Quadrider10]

HELP IS NOT FREE!!!! U owe m a few pics!!! Lol

 

[Budget_Blaster]

Id like to see this project sounds like a neat swap.

Definately be odd to see anything street legal powered by a blaster.

 

[mx5coco]

check out my build thread in the engine swap section... ill be getting better pics soon as well