i got the lights that people use from walmart and i bought the 20 watt lights to put in them and the blew out in like 5 min. why did this happen
having problems with the wally lights
- Thread starter TheWalkingPlague
- Start date
something about voltage regulator something something. i dont know blaster wiring, or any wiring for that matter.
Double check your wires. Your hot wire feed could be grounding out or shorting. And/or a bad regulator.
the regulator is under the hood on the kicker side, the tors and cdi are on the shifter side, but i'm bettin you touched the bulbs with your bare fingers ???, that gets oil/grease on them and they will blow after heating up, never touch the bulb, use gloves or a clean rag/paper towel
and you should be able to put a meter across the headlight wires one at a time to the ground wire, with the bike running, rev it and report back with the voltage, or find the spec in the manual???
and you should be able to put a meter across the headlight wires one at a time to the ground wire, with the bike running, rev it and report back with the voltage, or find the spec in the manual???
If it is a Halogeh bulb you can not touch it with bare hands.The oils in your skin gets on the glass and will make an extreme hot spot the will melt a micro hole in the glass and will let the Halogen gas out.
ok thanks awk08, and dakota they are holegan and i did touch them i will get new ones and try it out thanks so much
it probley your voltage regulator , i have mine in now 4 a month and they worked fine til i got good air and landed pretty hard lol
