Getting the rotor off hub???

[Quadrider10]

I just bought a new rear rotor, and I got the hub off, but I can not get the Allen. Bolts off. How can I get the out? I can't cut them, cause I still need the hub.

 

[Dem3500]

Did you strip the Allen heads out? If there not stripped go buy one of the socket style Allen key. Soak the bolts in pb blaster over night. Put the hub in a vice and give it another try with the ratchet. I've had luck that way more than once

 

[CARNZ]

you could cut the bolts, once the heads are off them the tension is going to be almost zero, slide the rotor off then use vice grips to grab and turn the bolts out

 

[Quadrider10]

Alright... I might have to cut them....I tried saoking them in wd40 ad heating them, but nothing.

 

[brandoz28]

Pb blaster or kroil will work a ton better

 

[Awk08]

heat them biotches cherry red, they'll come out

 

[rideyamaha09]

I had the same problem before when I swapped axles. Try drilling out the center of the bolt, just make sure you don't drill too big and go into the hub as well. It made the stuck bolts come right out for me after drilling them.

 

[slickerthanyou]

You need to put more ass into it! Use a 90 degree allen key, with a piece of tubing , i use an old steering stem piece, the factories are locktighted on. Just did that to the '05!

 

[Quadrider10]

Ight. Got them off. I just grinder them down till they were flush and it just piped rite off. Thanks everyone!

 

[Awk08]

Ight. Got them off. I just grinder them down till they were flush and it just piped rite off. Thanks everyone!

now you need to order new ones ?

 

[Quadrider10]

Naaa got ones from homedepot. 8mm 1.25