Well, my dad basically told me that i cant buy anything else for the go kart, until i have a good plan drawn up that my brother and i can make work. So im trying to draw up just some basic designs for us to go off of, but of course we will be changing it. I dont have the blasty frame here to measure, so i looked up the specs online. I knew the wheelbase was 43 inches, which this one site says. But it says that the length is 68 inches. So is that from the tip of the front bumper to the tip of the grab bar? And it says the height is 40.9 inches, but the seat height is only 29.1 inches. So can somebody tell me where they are getting these measurements from?
Also, could somebody go out and measure their frame width at the spot where the piece of tubing angles down that reinforces the a-arm mounts? I need to know how wide that is, and also how wide the frame is right before it goes up to the swingarm mount. So basically how wide it is in front of the motor, then how wide it is in front of the rear motor mount. I can post a pic with the spots i want measured marked if that will help. If not i might be able to get the measurements in a couple days. Itd just be a big help if i knew the measurements of the frame.
Also, could somebody go out and measure their frame width at the spot where the piece of tubing angles down that reinforces the a-arm mounts? I need to know how wide that is, and also how wide the frame is right before it goes up to the swingarm mount. So basically how wide it is in front of the motor, then how wide it is in front of the rear motor mount. I can post a pic with the spots i want measured marked if that will help. If not i might be able to get the measurements in a couple days. Itd just be a big help if i knew the measurements of the frame.
