Engine wont rev

[AkRider907]

Hey guys, I was riding my 00 blaster around, and my kickstart fell off.... I didn't notice until I was riding through a mud hole and I stalled out and couldn't get it started. Anyways, we got it out, and rode to my moms house. I was roll starting it, which I have done many times before. I got about 40 feet from my moms house and it bogged out and died.

I thought I fouled a plug, so I put a new plug in it the next day, so I could drive it back home. Nothing... I cleaned my carb out with a bunch of brake clean/carb cleaner. still nothing.. I reset my air/fuel screw, and now it will start and idle after about 40 kicks... It idles fine, but when I go to give it more than a quarter throttle it dies. I changed my coil and plug boot. Nothing.. sorry about the long post, but does anybody have any clue on what is wrong? I am clueless.. It has compression, spark, and fuel. But it bogs out and dies after 1/4 throttle. any help will be appreciated.

 

[Awk08]

if you haven't removed the tors unit, now's a good time to eliminate that from the equation, it will give those exact symptoms.............

http://www.blasterforum.com/do-yourself-20/how-remove-your-tors-655/

then run down thru the troubleshooting guide........

http://www.blasterforum.com/engine-13/my-general-troubleshooting-maintenance-30347/

 

[blasterBruce]

Could maybe be an air leak , What current mods have been done to it ?

 

[AkRider907]

Could maybe be an air leak , What current mods have been done to it ?

TORS removed. bored .40 over. rebuild around march, begining of march.
i did the heat cycle

do you think it may be the reeds?

 

[blasterBruce]

Could be the reads , Did you do a leak down test before the heat cycles ?

 

[AkRider907]

Could be the reads , Did you do a leak down test before the heat cycles ?

No, but I've put 50-60 hours on it. runs perfect.

 

[blasterBruce]

I would Advise to do a leak down test before you take the Reeds off or anything else

 

[blasterBruce]

You only Did 1 Heat cycle ?

 

[Blaaster]

Hey guys, I was riding my 00 blaster around, and my kickstart fell off.... I didn't notice until I was riding through a mud hole and I stalled out and couldn't get it started. Anyways, we got it out, and rode to my moms house. I was roll starting it, which I have done many times before. I got about 40 feet from my moms house and it bogged out and died.

I thought I fouled a plug, so I put a new plug in it the next day, so I could drive it back home. Nothing... I cleaned my carb out with a bunch of brake clean/carb cleaner. still nothing.. I reset my air/fuel screw, and now it will start and idle after about 40 kicks... It idles fine, but when I go to give it more than a quarter throttle it dies. I changed my coil and plug boot. Nothing.. sorry about the long post, but does anybody have any clue on what is wrong? I am clueless.. It has compression, spark, and fuel. But it bogs out and dies after 1/4 throttle. any help will be appreciated.

Roll starting it many times.

This concerns me, why roll start it , would it not kickstart.

What are your mods?

What is your jetting?

Why did you have to do a rebuild?

Have you ever leak tested it?