engine mount question

[joedirt5724]

The bolt for the rear arm goes through the engine and the frame needs the bushing kit. My problem is that the engine moves around on that bolt like the hole through the case isnt tight. Are their bushings on the case that can be replaced to tighten the engine mount back up when i get the new pivot bushings???

 

[joedirt5724]

anyone???????????

 

[REEDracing94]

dont thing so...does it move up and down??...there a small bolt in teh back under the engine u might be missing

 

[joedirt5724]

yeah the bolt moves in it like the hole has been rounded out and the bolt wobbles in it. ANd i kow its not supposed to. Where is this bolt ur talkin about???

 

[REEDracing94]

its a bolt that is small....it goes to a hole with a nut welded on the back... idk how to explain

 

[joedirt5724]

could you tell me where about it is???? i just need a general idea

 

[REEDracing94]

under the motor near teh back of it kinda by the swingarm bolt

 

[joedirt5724]

ok im gunna go c if i can find it and ill get back to ya in 5

 

[dustin7021]

hope this helps

 

[joedirt5724]

i found the bolt and im sure if i tighten that it will help. But its where that mains pivot bolt runs through the case is where i need to know if theirs bushings that i can replcae to tighen my mounts fully.

 

[YZ Otis]

Big washer #17 goes on each side of the case. Probably got left out . Don't see how they'd wear out.

 

[REEDracing94]

ive always been missing that washer and mine never moves lol

 

[lasxgames]

Yamaha Blaster Swing Arm Bushings and Bearings Rebuild:eBay Motors (item 200331228161 end time Jun-12-09 09:25:58 PDT)

 

[REEDracing94]

if your gonna get bearings you should go with a good brand and get pivot works.

 

[timsyfz]

^^^^^ shameless plug for his sponsor.. ^^^^

They are a good product though !