So here's my question. I want to get rid of the light/kill switch and key. I could leave the key wires unplugged and use a tether for the kill switch, and just use a button or toggle for the on/off for lights? Right?
Electrical Stuff
- Thread starter Blastizzle
- Start date
Nah, I tied the high and low beam together at the light. Next question is where in the hell can I find a bar mount toggle switch or on/off button like you push the button and lights are on then push again and lights are off. I can't find either. Or I'll take any slick ideas for a headlight switch but I don't want to drill my plastic to mount. Somewhere discreet but not hard to get to while ridin'.
You could try putting a switch under the gastank somewhere so you could just reach down and get to it while riding.
i just posted in the other thread, looks like you run older plastic does that mean you don't have a key whole in it, thats what i think im gunna use and the factory on/off switch just wired up to highs and lows, i don't really care if it runs all the time
Seen this QWIK PRODUCT SWITCH from Tucker Rocky Offroad
Or this-
MPS Handlebar Toggle Switch
and this-
Qwik Product Handlebar Switch
Just a few ideas or be cheap and just go to local auto store get a flush mount and make a bracket put it wherever ya like.
That's your "Slick" idea from your local forum roamer slickerthanyou!!I:I
Or this-
MPS Handlebar Toggle Switch
and this-
Qwik Product Handlebar Switch
Just a few ideas or be cheap and just go to local auto store get a flush mount and make a bracket put it wherever ya like.
That's your "Slick" idea from your local forum roamer slickerthanyou!!I:I
