I have a used dominator II axle that I bought but it did not include instructions. Problem is... I have a bag full of parts, but now of their assembly orientation. I understand the hubs / spacer / castle nut. But the part I am lost on is the c-clips the lock thing (instead of the axle nuts). Someone has to have this axle so if you have a picture or can describe the order etc to give me a hand it would be appreciated. Thanks!
Dominator II axle assembly instructions
- Thread starter desgre90
- Start date
Nvm, I started trying pieces and assembled the axle. I ended up with a few extra parts but that is normal... right?
not unless they sent you extra parts..
my durablue eliminator has....
axle, hub nuts, axle nut, 2 spacers, and the c clip..
from left to right should go like this..
cotter pin,hub nut, hub, washer, c clip, hub nut, sproket, brake hub, washer, hub, hub nut, cotter pin.
if yours is a adjustable like mine the 1'' spacers will go between washer and hub for max width, or spacer between hub nut and hub for minimum width
I was more worried about from c-clip to c-clip configuration, the hub end is easy to figure out. The two pieces I was unsure about... one went in the carrier in place of where the stock axle had the thing that looked almost like a bearing. It fit in there and the seal was double grooved like the piece was so that worked out. The other piece I wasn't sure about was a spacer, but I put that on the brake rotor side (since it was too loose to be on the carrier / sprocket side. I put the spacer on after the brake rotor, then put the splined piece / c-clip retainer on. Everything fit right so I guess we'll find otu when I go to bolt the axle up when the swing arm comes in the mail. And as far as the extra parts.. there was a broken washer in the bottom of the bag. That is the only extra parts I had lol, but just said that to toss in some humor.
Similar threads
