doing my oil injection block off today

[TeamCarr]

i have the kit and im doing it this afternoon. im running to walmart and want to know if there is anything i should get to make my job faster/better. also any tips on the actual process would be greatly appreciated.

 

[brandoz28]

is it the vito's kit? i think it has everything you need in it, minus tools, so assuming you have all the tools it shouldn't be a big deal

 

[TeamCarr]

is it the vito's kit? i think it has everything you need in it, minus tools, so assuming you have all the tools it shouldn't be a big deal

yea its the vitos kit

 

[blastermaster01]

yeah you should be fine then it comes with everything I think.

 

[sr5bidder]

I just used hanger 9 2 part epoxy on both sides of the hole after cleaning/ grinding the surfaces

I want to get the idle screw a guy I know has the tap for the install but cant find the Ilde screw only...anyone know what it is originally from? or who has the screw and spring only?

 

[TeamCarr]

I just used hanger 9 2 part epoxy on both sides of the hole after cleaning/ grinding the surfaces

I want to get the idle screw a guy I know has the tap for the install but cant find the Ilde screw only...anyone know what it is originally from? or who has the screw and spring only?

what hole do u use the epoxi on?

 

[sr5bidder]

the hole that is present after removing the oil pump shaft and gear...where everone buys the block off plate for

 

[J4M1E333]

i got the idle screw off eGay for a couple of quid and that was from the US, will try and find a link now, here ya go

NEW YAMAHA BANSHEE & BLASTER IDLE SCREW 87-2006 : eBay Motors (item 310174871205 end time Feb-11-10 16:10:00 PST)

 

[sr5bidder]

i got the idle screw off eGay for a couple of quid and that was from the US, will try and find a link now, here ya go

NEW YAMAHA BANSHEE & BLASTER IDLE SCREW 87-2006 : eBay Motors (item 310174871205 end time Feb-11-10 16:10:00 PST)

thanks manI:I

it say I must use the tors elemination kit ..is there a reason I cant just use this screw for awhile with the tors junk on top of my carb untill I come up with either a new carb setup or the cap and cable kit?

 

[Budget_Blaster]

i epoxied mine as well but i made my block off plate too easy to do just couldnt see spending the money on it

 

[J4M1E333]

there should be an idle screw on the tors if you still have it on the top of the carb!! if not im guessing you could use this, it means you drilling and tapping the carb, but that aint to hard providing you get the right size thread pitch and width Etc.