cutting out

[liljatownboy]

after riding the blaster for a while it starts to cut out and wont run like it should if you let it sit for a min or two you can start it and ride it for about 25 feet and it will do it again and when it starts to cut out i pin the trottle and sometimes it will keep going till i let off and slow down to turn then it does it again.

 

[NOVIS]

try cleaning the carb. happened to my old kx65 and carb just needed a good cleaning. and a spark plug.

 

[Ready2rev]

i had the same syptoms with mine. just move the clip up on the jet needle inside the carburetor cap it will richen the mixture from 1/8 to 3/4 throttle. the main jet controls mixture from 3/4 to full. the reason why it would cut out would be that its running lean. hope that helps..

 

[liljatownboy]

ive clean the carb 4 times thats not it im guessing plug but havent got one yet but its like it loses fire for a sec. then gets it back

 

[blaster99]

get a plug braaa

 

[liljatownboy]

i dont have the oem woodruff key in it would that be it?

 

[custom2stroke]

i had the same problem before but not on a blaster but still a 2 stroke. it ended up being a bad spark coil. when it was cold it would run good until it got warm then shut down. the coil would heat up after driving for awhile then resistance would go up in coil and reduce the spark and kill the motor. i would let it sit for a little bit and it would start right up. everything else sounds the same as you also as the symptoms i had. i replaced coil and never had the problem again.

 

[liljatownboy]

well its a new coil but it may be it thanks alot

 

[L.T.]

Get a new plug and check the coil