I recently had my cylinder bored to .010". I purchased a new wiseco piston kit. I rebuilt my carb and installed oil block kit and tors delete. Upon assembly of engine I install a new fixed stator. Quad started on third kick while being choked. After letting I'd run for a good while I pulled in clutch lever and put into first gear. Quad lunged foward and stalled. Anybody have any idea on what's wrong?
Clutch issues
- Thread starter John Uschan
- Start date
change the oil
set the clutch lever cable to specs.
it happens to alot of dirt bike quads sometimes depending on the condition of them
also warming it up properly before putting it in gear.
set the clutch lever cable to specs.
it happens to alot of dirt bike quads sometimes depending on the condition of them
also warming it up properly before putting it in gear.
The gentleman I purchased it from said it has sat for a while. I have had case split because it was leaking. I have fresh oil in it now and all back together.
I took them all out and put them back in when I rebuilt the engine. I'm starting to think I may not have the clutch adjusted right.
Take the clutch cover off and adjust the push lever that the clutch cable hooks up to...loosen nut and turn Phillips head screw on the clutch basket rod . Make sure to line up the push lever point with the line on the case...Pushing the lever forward as you turn the screw to line up with the line on the case . Re-check after you lock the nut down with locktite
Now when I pull in my clutch lever the whole clutch assembly moves. It's does not go back to normal position when clutch is released. So when I pull clutch instead of the pressure plate moving the whole assembly moves. Any ideas?
i seized my push rod to the little ball on mine on accident. i had to crank it in neutral and have someone give me a push then i put it into first gear.
