clutch help

[Zwiser]

if you pull the clutch in and its in gear it should move freely right, well mine doesnt and i think it has somthing to do with my la sleeve big bore kit because the little holder for the cable is moved to the side of the cylinder any thoughts on how i can fix it

 

[Whitty21]

once mine is moved in gear without the clutch in, it wont move with the clutch in in gear after that, but if i put it in neutral and then in gear with the clutch down it moves fine, unless it moves in gear without the clutch...

 

[1bad442]

a pic would be helpful because mine is allready on the left side rear stud of the jug??????

 

[brandoz28]

a pic would be helpful because mine is allready on the left side rear stud of the jug??????

mine too

 

[Zwiser]

alright getting pic now

 

[Zwiser]

 

[brandoz28]

do you still get full motion out of the lever?

 

[Zwiser]

yeah the lever is just how it should and the plates move. also if i put it in gear and kick it with the clutch in itll move

 

[1bad442]

i would try and bend that bracket down a lil bit so the cable doesnt come out at such an angle can u start it in nuetral and then put it in gear??

 

[Zwiser]

ok will try in alittle thxs

 

[Zwiser]

it stalled out, 442

 

[slickerthanyou]

We need 90bronco to chime in here. I think you may have to make a bracket for it looks to be too much of angle.

 

[brandoz28]

if the arm still moves as far as the cable pulls, its a clutch adjustment issue


once again....did you have the clutch apart?

 

[Zwiser]

i didnt have the clutch apart at all but plan on it when i install oil seals

 

[scotj77]

you are probably going to have to adjust the clutch internally if you have the cable loosend all the way. looks to be pulling on the clutch when you attach the bracket to the jug. or you will have to make a new longer bracket to allow the lever to return to the right position.

 

[Zwiser]

the clutch feels exactly like it should it just doesnt want to engage

if thats what you were trying to say

 

[1bad442]

the clutch feels exactly like it should it just doesnt want to engage

if thats what you were trying to say

u mean it doesnt want to disengage

 

[blasterdad]

What about this!
Magura Hydraulic Clutch Yamaha YFZ450 YFZ 450: eBay Motors (item 120359950213 end time Nov-27-10 13:08:50 PST)

 

[79 bronco]

I had to bend my bracket a little...

 

[79 bronco]

We need 90bronco to chime in here. I think you may have to make a bracket for it looks to be too much of angle.

90bronco Who lol