im working on a blaster motor i got the other day and i cant seem to get the cases to split. i dont have i case splitter is there any trick to doing it without one. does anyone have a link to where i could get one if i can get these apart.
case splitting
- Thread starter TopTechKid27
- Start date
After you get all the Phillips heads out all you need to do it tap around where the two cases meet with a rubber hammer.
Get a cheap case splitter. Its much easier than the hammer technique.
- Harbor Freight Tools - Quality Tools at the Lowest Prices
- Harbor Freight Tools - Quality Tools at the Lowest Prices
He was looking for a simpler way to do it immediatly. Im tired of all of you wannabe know it alls in here.You own kids Atvs. And most the time its kids asking for help. Grow up and help or get off this forum. BTW, this forum BLOWS.
it's obvious from your posts earlier, that you're a previously banned member and just here to start sh*t, but lack the balls to reveal who you really are
have a nice life on some other forum ahole I:I
you're outta here !
Last edited:
If a job is worth doing it is worth doing well!
Do we take offence at the highlighted statement, or treat it with the contempt that it deserves.
We may own kids toys but it takes real men/women to ride them.
Shame, shame, shame, one gets all riled up and peruses the dictionary for unknown offensive words to type and Awk pulls the plug.
What is one to do to rid oneself of all our aggressions..Just joking.
Good on yer Awk we do not need jokers like him riling up the members, but it was fun while it lasted.
What is one to do to rid oneself of all our aggressions..Just joking.
Good on yer Awk we do not need jokers like him riling up the members, but it was fun while it lasted.
Good on yer Awk we do not need jokers like him riling up the members, but it was fun while it lasted.
did you miss his earlier thread ?
been watching him dig his grave all day, then i jambed that needle in !!!!
