carbs arn't bullet prof

  • Thread starter Thread starter rambo241
  • Start date Start date
R

rambo241

Guest
I have had this carb laying around for awile and decided to put it on today, it is a 38mm(HUGE). The thing was so big that even after I got it jetted right it ran like crap, cleaned it changed jets about 100 times and tried again, doggey as hell. I got pissed off at it and took it out and shot it with the AK:-D stress relief. I am going to get a smaller carb, i want won that will hilp my top end but not lose any bottom end power, any sugjestions?
 
she's bored 60 over, milled head, v-force 3 reeds are just my engine mods.
 
I probably wont put any other mods on it for a while. That is about the same size i was thinking.
 
Thanks man, what do u run a kein or a Mikuni. D slide or flat slide.
 
I prabably get a keihin, seeing as how that Mikuni i had didn't even stand up to FMG round lol. Nice Blaster by the way.
 
thanks, the only mikuni i have delt with was the stock one and i always here people including my mechanic complain about how hard they are to tune compared to keihin. naw i dont think much can stand up to a fmg round lol
 
i get my FID card march 12, and what am i doing right after i get that, going to buy a gunnnnnnn