I have to get a new carb for my Blaster.The top is striped.I don't know if I can go a little bigger or stay stock.All I have is an FMF pipe-V3-High flow filter and +4 tm.If I can go a little bigger.What size and model???Thanks.I:I
Carb size
- Thread starter blasterdemon7
- Start date
i dont wana start another thread so ill ask here..i have a 30 mm kielin on my blasty and all i have is an fmf full system exhaust and no airbox lid/airbox haha. is it too much for my bike? or should i downsize? ive leaned the main out quite a bit to make the high rpms nize and zippy but my low end still is boggy and it wont idle..i have a 65 pilot in it. now my question is if i had to lean out the main that much..do i have to lean out the pilot to get it to idle and not bog when i hit the throttle? thanks for any help
my mods are in my sig and i run a 30mm mikuni no problems, added a lot of upper rpm power when i switched to this bigger carb
Will I need to change the boot for a 28 or 30????Oh.And this is a shock!!!!No post by YB????????!!!!!!!LOL.
hey dakota i have the stock intake boot on with my 30..its a really tight fit but it goes on..i just dont know if having it stock minimizes the effects of a bigger carb..but it will fit
http://www.blasterforum.com/engine-13/bigger-carb-any-benefits-22723/ Sorry.Didn't see this one when I posted.My bad.
Ok.I got the carb and boot info I need.I just need to know about the cable.Do I need to change or mod it to work?????
