Carb problems

[Ky laster]

The round slide in carb turns and gets cought on idle screw and goes wide open then I take idle down and can here slide fall down

 

[Ky laster]

If take idle screw almost all way out it don't stick but if I screw it n it sticks went bout 2 or 3 weeks with out doing it then the round slide comes out of it's groove and sticks help

 

[Herpderplol]

Sounds like you need a new slide

 

[Fast6hand]

Maybe a gouge/groove in the slide where the idle screw sits. Pull the cap to inspect.

 

[Larry's Shee]

Pin in carb that keeps slide from spinning, may have came out.
Just need to inspect carb closely.

 

[Ky laster]

Where is a pin that suppose to hold it from spinning never heard of it? But I'm still having carb problems

 

[speedyslyder]

 

[jus_me]

A bent needle would also help in binding it up.. ^^^ like stated above, you need to inspect carb closely and that all the parts in your carb are actually for a blaster and not possibly for a Banshee (specifically the slide)