Carb default settings?????? HELP!

[Blaster200UK]

is the a post or website where i can find out the default settings for my carb?
i need the default settings so i can set my carb before i put it on the quad. thanks

 

[CARNZ]

prwtty sure its 32.5 pilot 3rd needle clip 230 main. airscrew 1.5 turns out

 

[Blaster200UK]

thanks, where did you find out this information?

 

[CARNZ]

from my stock carb.

 

[Blaster200UK]

hi, just doing it now, ,on the pilot screw what do you mean by 3rd needle clip?
how many turns out should it be?

 

[Surfrjag]

what mods do you have? we can probobly tell you pretty close to what you should be running. when u take your slide and needle out there is a c clip that can be adjust to move the needle up and down to adjust fuel mainly in the midrange. also check out the engine section there is a sticky on what jetting works for most diff mods and elevations. good luck

 

[Blaster200UK]

Hi i have no mods what so ever. YET
and i have set the pilot screw to 1 and a half turns out
and the pilot jet you mean under the float ?
where is the air screw on these?

 

[caseywoods5]

the stock main jet isn't 230, it's 240, i just recently jetted my bike for a fmf pipe and open airbox lid. the stock was a 240 and i am putting in a 290 for the pipe and no airbox lid.

 

[Whitty21]

the stock main jet isn't 230, it's 240, i just recently jetted my bike for a fmf pipe and open airbox lid. the stock was a 240 and i am putting in a 290 for the pipe and no airbox lid.

you are wrong its 230, some manuals even say 220 for some reason, but i know for a fact it is 230

 

[Blaster200UK]

do you even have a air screw when the tors has been removed? it shows me the air screw on the tors system in the manual, but looks like its been removed.

 

[CARNZ]

the stock main jet isn't 230, it's 240, i just recently jetted my bike for a fmf pipe and open airbox lid. the stock was a 240 and i am putting in a 290 for the pipe and no airbox lid.

stock is 230....
......
.....

 

[Whitty21]

i think the floats need set to 20mm too, dont quote me though

 

[caseywoods5]

if the stock is 230, then why did i have a 240...?

 

[Whitty21]

if the stock is 230, then why did i have a 240...?

good question lol, previous owner i guess

 

[Blaster200UK]

thanks guys, where is the idle screw located?

 

[piezzi]

thanks guys, where is the idle screw located?

Lift off your seat and look under the rubber flap near the gas tank. There's a big ol' screw on the left side that's for adjusting the idle.

 

[NEONNIGHT34609]

what should this be set at ? is there a starting point on that screw ?

Lift off your seat and look under the rubber flap near the gas tank. There's a big ol' screw on the left side that's for adjusting the idle.