Blaster will not Rev high, no powerband

[Larry's Shee]

I usually have to use a mag glass to see them.
Check reeds.
It may sound weird, but check that piston is facing the right way. Pull exhaust, rotate to top dead center, if you see holes, it's not right.

I also suggest disabling the TORS. IT causes all kinds of weird problems.

https://www.blasterforum.com/threads/03-06-tors-removal-diy.41973/

 

[Larry's Shee]

I usually have to use a mag glass to see them.
Check reeds.
It may sound weird, but check that piston is facing the right way. Pull exhaust, rotate to top dead center, if you see holes, it's not right.

I also suggest disabling the TORS. IT causes all kinds of weird problems.

https://www.blasterforum.com/threads/03-06-tors-removal-diy.41973/

 

[Rastaman]

I usually have to use a mag glass to see them.
Check reeds.
It may sound weird, but check that piston is facing the right way. Pull exhaust, rotate to top dead center, if you see holes, it's not right.

I also suggest disabling the TORS. IT causes all kinds of weird problems.

https://www.blasterforum.com/threads/03-06-tors-removal-diy.41973/

Thank you.. I just ordered new Reeds tors Eliminator kit when they come in I will change them and update.... Thanks for all the help

 

[Larry morris]

My blaster will not rev very high. It has alot of bottom end power but has no top end. it almost sounds like there is a rev limiter kicking in? The compression is 150psi and the carb is clean. I dont know if it is an electrical issue or mechanical. Any and all advice would be great.

thanks
joe mac

Your tor,s will regulate high rev try eliminating it

 

[Larry morris]

It just feels like it has a governor on it. Also just re-did the whole gear system and when I shift it will get stuck in between gears and I have to shift up and down repeatedly for it to get in gear?

You said ya pluged tors in and it started sounds like a tors problem i would eliminate it there is a tors removal video on youtub that will help with this just searxh blaster tors removal

 

[BlasterDean]

After you set the float... problem fixed. ?