Blaster service limits

[twosmoke]

Hey it's me again, wondering if anyone has access to a manual so they can give me the service limits for my cylinder. I'm honing the sh*t out of it to get some scratches out and don't want to take off too much stock. I don't have the money for a bore job right now nor do I have the tooling to do it on my own.

The standard bore size is 66mm, or 2.600", if I end up honing until its .005 over measuring 2.605 would it still be able to accept a standard bore piston and rings and have good enough compression?

 

[blasterboy91]

your question has been answered frillions of times to bro...i ferget what section its under but theres a manuel you can download an it gives you all that info....look around man...

 

[samolia]

dont cheap out on the quad or your ganna regret it later...
that isnt even ganna work anyways spend the $$$

 

[twosmoke]

your question has been answered frillions of times to bro...i ferget what section its under but theres a manuel you can download an it gives you all that info....look around man...

Ok I'll take a look. I did try searching around for service limits but found nothing..

 

[burnin'_oil_2001]

Ok I'll take a look. I did try searching around for service limits but found nothing..

If you search for "blaster manual" you will find posts with links to online service manuals.

 

[98blaster]

dude the answer to your question is no the service limit is 2.602 just buy a slug and get it bored you'll be happier in the long run with knowing its done right