Blaster Running Funny!!! Need Serious Help

[Blaster30]

Hey guys my blaster is running funny well to start i have about a 4 month sitting spark plug, and 4 month sitting gas...

My problem is I have Tors deletion, new uni air filter, newly rebuilt carbeurator and how ever it only stays idling with me having my hand on the throttle and one hand pulling the choke all the way out and even with me still holding the throttle and i let go the choke it will stay on any where between 7-10 sec then it dies out and to remind you i just rebuilt it today, and theirs no flooding, over a 100 psi of compression on cylinder it has new rings, and theirs no air leak...

 

[Awk08]

are you trying to use that old fuel ?
you'll need fresh fuel mixed 32:1 with a good 2 stroke oil, or injection oil if running that ?
and a new b8es plug
have you completely disassembled and cleaned the carb ??..........

http://www.blasterforum.com/general-support-17/how-clean-your-carb-pics-209/

 

[Blaster30]

Yes, I just put a brand new carb rebuild kit on their and replaced everything even cleaned the carb...

 

[Awk08]

carb definately getting fuel/petcock and screens in tank clean and flowing good ?
new plug ?
airfilter new or cleaned and oiled ?
exhaust free from blockage ? try disconnecting it and see if it starts
floats and airscrew adjustments ?

http://www.blasterforum.com/carburetor-138/float-heights-how-adjust-them-50565/

http://www.blasterforum.com/carburetor-138/adjusting-your-airscrew-pilot-jet-51060/

did you put the brass washer back under the main jet ?

 

[Arnold]

How did u delete the tors? Did u just cut wires or get the kit? If u got the kit di u install the idle screw?

 

[Blaster30]

To Awk Do you have a cellular number i can reach you at that way i can call you tomorrow and maybe you can listen and hear it over the phone... as well as direct me if you dont mind...

To Arnold when i did the tors deletion i put it on and cut the wire connected to the safety switch on inside and rapped them around one another

 

[Awk08]

try a few more things on your own before we open the tech lines
you need to learn to do this stuff............

tors delete's...........

88-02:
http://www.blasterforum.com/do-yours...your-tors-655/

03+:
http://www.blasterforum.com/engine-1...t-i-did-48477/

i have them listed in this troubleshooting guide, run down thru all of it, then maybe we'll talk after you have more answers.........

http://www.blasterforum.com/engine-13/troubleshooting-maintenance-guide-30347/

 

[Blaaster]

I am interested in how long did it hold 7psi on the leak test?

 

[Arnold]

As Awk said run thru the trouble shooting guides for your year, there are a few different steps to take for the tors delete. If u replaced the cap on top of the Carb then I don't have an idle screw so u will need yo buy the idle screw kit for the tors delete.