Blaster is done but have a few tuning question

[Budget_Blaster]

Ok i recently got it all done and ready to test ride and took it out but the bottom end torque feels to be lacking or delayed but then it just comes alive and wow it hauls.

Its been quite some time since ive had a 2 stroke and cant remember if this is just the nature of the beast.It revs fine and runs greatthroughout the rpms one kick to fire up even after days of sitting it just seems to be lacking a little on the low end any ideas or is this just the nature of the beast.

Ill get pics up soon it turned out really well.Cant see it very well now covered in mud.lol

 

[Budget_Blaster]

BTW it is running rich right now but that is purposely so the motor has a chance to break in.

 

[xjma]

did you put a new top end in?? I would do the proper break in procedure before trying to hammer down on it. if you don't do the break in, you risk having a poor seal from the rings to the cylinder and not getting the full power potential out of it. so break it in slowly!

 

[Budget_Blaster]

Its been broken in properly i did it on the bench so thats not an issue.

My buddys who all still ride 2 strokes that ive asked said thats normal but theyre into dirtbikes not blasters and every machine has its own qwerks.

 

[blasterdude14]

well being rich is a likely factor in it
How exactly did you do the break in? just because you did it at a beach doesnt make a difference

 

[xjma]

He did it on the bench, not the beach!!

Rich could be your problem, but break-in is more important than most people know.