i just change my piston to a size 67mm and bored the cylinder and i'm using stock reeds. the bike tends to die out, something is not right. what do you think it is? it runs but not for long...thanks in advance!!!
blaster dies out...help please...
- Thread starter bumble bee
- Start date
i think the carb is still clean and as for the filter i don't have one.the bike can start but dies out after riding it for awhile...
alright let me get a filter and try it out hope it works cuz i really wanna ride thanks alot guys i'll let you guys know if thats the problem
i put the filter on it starts but it dies out if you don't press the gas, you thinks it's my idle???
if you only "think" your carb is clean take it off and clean it. take the pilot jet out and clean that, i bet its your problem.
Does it smoke when it starts or no smoke? If you pull the plug is it wet with gas or dry? Have to took a multimeter to the ignition coil to check the resistance ohms?
you know what i bought a new set of boyesen super stock reed petals and installed it, but it doesn't sit right the petals are not flush with the cage...
the bike smokes when it starts, what plug are you talking about,and as for the ignition i don't know how to read multimeter
if it dies when u hit the gas.do you have ur tors still hooked up?also your parking brake switch
pilot jet sounds like it pluged plus running wit out a filter can make it dirty quick. plus make sure the four holes on the sides of the pilot jet are cleaned out as well. and if too much gas at idle then check float hight and needle seat for wear.
