Aintivibe Stem help.

[1995blaster]

well i was thinkin about makin a aintivibe clamp on stem. Well turns out that damn yz otis already did that. But he did help me out buy finding that cr125 bar mounts would work (which is a great idea) heres a pic of what he did.

Mine was the same design but mine had more fabbrication becuase he found the cr mounts like these 1984 HONDA CR125R- HANDLE BAR MOUNTS AND BOLTS | eBay Well im thinkin i can make the same thing he did. But look at the bushing on the mounts how they slope down i would have to get a seperate set. Im thinkin from these guys. Thomas Caserta - Rubber Gaskets, Rubber Tubing, Rubber Washers, Rubber Bushings, Rubber Cord Ill prob rock these for only a lil if i make em to see if i like it and then make this like strokedtater did

but with the cr mounts. any ideas? sorry for the bad write up btw im really tired
i would make pretty much the same thing as tater but with the cr mounts and diff bushings.

 

[1995blaster]

if these are the right sized bolt hole these could work??
Rubber Handlebar Bushing Kit For Harley Big Twins & XLs | eBay

or if that fails i could cut this to length and drill a hole. bit i prefer it to be not bigger than 1 inch around 2 is just tooo bigg
Rubber Handlebar Bushing Kit For Harley Big Twins & XLs | eBay

 

[3 Wh33l3r Rid3r]

you can buy the sloped pieces from lonestar racing for 8 bucks a piece and that would fit the clamp mounts perfect. You really need those pieces to get the best fit on the clamp. You will have to call lonestar for the pieces because they aren't listed on the site. All you would have to make is the middle bar. I have a diy write up on a anti vibe stem you could build the whole stem, its pretty easy.

 

[1995blaster]

thanks man i saw that you had a write up on it. if this works out and i actually like it ill prob get a clamp like your but the 64$ one on egay. do you have pics of the pieces from lonestar?

 

[3 Wh33l3r Rid3r]

Only pic I have is in that thread. My hard drive crashed and lost all my pics.