2006 Blaster, special edition. Starts fine, idles fine, but when accelerator is pressed it almost dies. Figured it was the TORS, so followed steps on here to bypass it. Same results, no change. Messed with parking brake switch, can tell when it is engaged but back to normal when not engaged. Changed spark plugs, drained carb bowl, drained gas, nothing. Only time throttle can be opened is when gas is turned off and it runs out of gas, will rev wide open and then dies when out of gas. Any thoughts? I'm at a loss.
2006 Idles but dies when throttle is pressed.
- Thread starter kgriff
- Start date
Check float height, wifesblaster has a good thing on that.
As for the parking brake, just pull out the switch and cut it off, your problems are fixed then
As for the parking brake, just pull out the switch and cut it off, your problems are fixed then
Do these things in this order.
Unplug parking brake sensor
Clean and oil air filter
Completly disassemble carb and clean
Set float height when you assemble the carb
Compression test
Inspect reeds
Leak test
List mods and jetting. You need to leak test if you haven't already. Dont worry about it reving wide open when it runs out of gas. It is because the lack of fuel creates a brief lean air fuel mixture.
Unplug parking brake sensor
Clean and oil air filter
Completly disassemble carb and clean
Set float height when you assemble the carb
Compression test
Inspect reeds
Leak test
List mods and jetting. You need to leak test if you haven't already. Dont worry about it reving wide open when it runs out of gas. It is because the lack of fuel creates a brief lean air fuel mixture.
You need to cut the wires! otherwise it will just keep bogging!!
(even more if that WASNT the problem lol )if it passes all of the tests these guys said, i would check the stator. my buddys went bad and did the same thing
Similar threads
