2 things

[Blaster95-97]

which carb is better in prefference to jetting and other sorts. oko 28mm or 30mm? if i want to do a 2-3 mil crank upgrade, would i have to get a bigger carb?

number 2, does anyone have a 250mj, i want to do an oil injection delete and can't fina a mj250

thanks I:I

 

[Herpderplol]

Most people skip right over the 28mm, it give you no difference performance, and its just a jetting problem....

 

[blasterdemon7]

Some people have not had good luck with OKO carbs.

 

[Blaaster]

Oko carbs are renowned to give jetting headaches.

Stick with Mikuni or Khien.

 

[jus_me]

I think i have a 250 main. I'll check than pm you later..

 

[gb blaster]

Oko carbs are renowned to give jetting headaches.

Stick with Mikuni or Khien.

I'll second that!!

I no I have a 250 main at the house, that's what I ran with my Dg pipe before I upgraded! I'll look. If just doesn't have one I'll pm you. Just got a pj 34 won't need the 250 anyways.

 

[jus_me]

I have basically every size but a 250. I thought i did, sorry man. I don't know what i could have used them on.

 

[Blaaster]

If you want to simulate a #250 main jet, run a #260 and rather than pre mix at 32:1, mix at 25:1.

Owing to the lesser content of gas in the mix it equates out to just about one size jet difference.

Plug chop to confirm.

 

[Blaster95-97]

I think i have a 250 main. I'll check than pm you later..

were you able to find one? i had to take my carb off again because i got water in the carb so just pm me if you have it I:I thanks

 

[Blaster95-97]

I'll second that!!

I no I have a 250 main at the house, that's what I ran with my Dg pipe before I upgraded! I'll look. If just doesn't have one I'll pm you. Just got a pj 34 won't need the 250 anyways.

jus_me doesn't have one. would you be a kind gentleman and pm me about it? thanks I:I

 

[Blaster95-97]

If you want to simulate a #250 main jet, run a #260 and rather than pre mix at 32:1, mix at 25:1.

Owing to the lesser content of gas in the mix it equates out to just about one size jet difference.

Plug chop to confirm.

the only mj i can find are 300 plus :-/

 

[Blaaster]

the only mj i can find are 300 plus :-/

Better get the correct size as a #300 will be way too big.

 

[Blaster95-97]

Better get the correct size as a #300 will be way too big.

yeah i know. that would be if i ran a new pipe, but plug chop to confirm. i stripped a bolt in my plastic air filter ox, so i might just make an aluminum one for it. after i get it out. it's being a pain in the butt to get out tho!