2 THINGS ABOUT WIRING

[rad-blaster230]

when i turn my bars all the way to the left it kills my engine, but only at idle
i couldn't see any tight wires

and also i got a new carb WITHOUT tors and i want to take off the tors wires in the throttle box and just disconnect the whole thing COULD ANYBODY TELL ME HOW TO DISCONNECT

i have a 2005 blaster

 

[greenblaster]

it could be from your throttle cable, try having a higher idle and turning it

 

[Awk08]

i agree, mine revs a little when the bars are turned, try fooling with the throttle cable where it passes over the frame under the tank, where it's ty-rapped, pull it a little each direction and see if that helps
and if you have a non tors carb, just follow and cut out all the wires, and unplug at the "brain" under the hood

 

[Little-J]

to remove the TORS from a 2003+ model, cut the two thin wires coming out of the CDI box.. These are two striped wires that are thinner than the rest.. The bike will now idle but wont rev.. One of the wires needs grounding to the frame to ELIMINATE the TORS..
strip them both and try which one works..

Connect the wrong one, it will stall, connect the right one, TORS goes Bye-bye..

 

[Little-J]

check the engine stop switch still works after you do this.. The wires are Black/yellow and Black/white... I think ( lookin at wiring diagram ) you need to ground Black/Yellow, and the Black/White may go to the kill switch.. Remove the Black/Yellow and ground it first.